 |
| Quantity: | |
|---|---|
KYDBL4875-1E
Keya
KYDBL4875-1E
48v 1500w Close Loop Bldc Controller 75A
This 48V 1500W bldc controller input voltage range is DC 10V-55V, support 24V 36V 48V bldc motor, the max current reach 75A, continuous current 40A, support RS232, CAN open comminucate, RC, PWM, analog signal control. it also suppot 500ppr - 2500ppr optical encoder feedback, can control motor speed and position. can be widely used in automation system.
II.product parameter
| Controller type | Single channel brushless dc controller |
| Voltage Range | DC10-55V |
| Continuous current | 40A |
| Max current | 75A |
| Work mode | Speed open-loop, close-loop control, torque close-loop control, position close-loop control |
| Operation mode | Safety forward & reverse control, four-quadrant operation, support regeneration. |
| Feedback | Hall sensor, 500ppr - 2500ppr Incremental encoder |
| Control ways | RS232, CAN-Open, PWM, Analog voltage(0-5V or 0-2.5V-5V), RC Radio, Jostick |
| Protection | overcurrent, overheating, overvoltage and short circuit will start the protection function. |
| Working temperature | -10℃-- +60℃. |
| Boundary dimension | 148mm * 117mm * 75mm |
| Weight | 1000g |
| Applied range | This bldc controller be widely used in Crawler robot chassis, explosive-handing robot, inspection robot, fire fighting robot, service robot, medical robot, automatic guided vehicle, self guided vehicle, rail guided vehicle, unmanned ground vehicle, robot arm, intelligent warehouse, intelligent system etc |
Hall / Encoder Input port
Standard DR9 inerface, the port detail definition as below:
| Pin | Definition |
| 1 | Output 5V DC (20mA) |
| 2 | Hall A |
| 3 | Hall B |
| 4 | Hall C |
| 5 | 0V |
| 6 | Output 5V DC (20mA) |
| 7 | Encoder A+ (support 500ppr - 2500ppr optical encoder) |
| 8 | Encoder B+ (support 500ppr - 2500ppr optical encoder) |
| 9 | 0V |
Control Port
Standard DR15 inerface, the port detail definition as below:
| Pin | Function | Remark | I/O |
| 1 | Alarm output | Can be set | DOU2 |
| 2 | Tx-out | RS232 Tx | |
| 3 | Rx-out | RS232 Rx | |
| 4 | |||
| 5 | GND | ||
| 6 | CAN-L | CAN-Low | |
| 7 | CAN-H | CAN-High | |
| 8 | |||
| 9 | Alarm output | Can be set | |
| 10 | Enable | Effective at high level | DIN5 |
| 11 | DIR | Effective at high level | DIN4 |
| 12 | Signal input | analog signal / pulse signal input | P/AIN3 |
| 13 | GND | ||
| 14 | Output 5V DC (20mA) | ||
| 15 | BRAKE | Effective at high level | DIN6 |
If you need more information, please leave message, we will try our best to support you on this bldc driver.
Application
